A-A-52088A
5.4 End item circumference testing. Each lot of ropes shall be measured for circumference in accordance with Method 6003 of FED-STD-191. Any circumference not within the specified tolerances shall be classified as a defect. The lot size shall be expressed in units of tubes or coils of rope. The sample unit shall be expressed in units of tubes or coil of rope. The sample unit shall be one tube or coil of rope. The inspection level shall be S-3, and the AQL shall be 2.5.
5.5 End item testing. The ropes shall be tested for minimum breaking strength and length per pound in accordance with Methods 6016 and 6004, respectively, of FED-STD-191. The lot size shall be expressed in units of tubes or coils of circumference, and shall be 55 feet for ropes less than 1-1/8 inches in circumference. The lot shall rejected if one or more sample units fail to meet any requirement specified. The sample size shall be in accordance with table III.
TABLE III. Sampling for tests.
Lot size (tubes or coils) |
Sample size (sample units) |
800 or less 801 up to and including 22,000 22,001 and over |
2 3 5 |
6. PACKAGING
6.1 Preservation, packing, and marking. For acquisition purposes, the products shall be preserved, packed, and marked as specified in the acquisition order (see 7.3c).
6.1.1 Commercial. In the absence of detailed instructions in the contract or purchase order preservation and packing shall be in accordance with American Society for Testing and Materials (ASTM) D3951, "Standard Practice for Commercial Packaging".
6.2 Palletization. When specified (see 7.3d) rope shall be palletized in accordance with
MIL-STD-147.
7. NOTES
7.1 Part Identification Number (PIN). The following PIN procedure is used for government purposes and does not constitute a requirement for the contractor.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business