MIL‐DTL‐2522F
3.8 Workmanship. The finished cord shall conform to the quality and grade of product established by
this specification.
4. VERIFICATION
4.1 Certificate of compliance. Where certificates of compliance are submitted, the Government
reserves the right to check test such items to determine the validity of the certification.
4.2 Conformance inspection. Sampling for inspection shall be performed in accordance with ASQ
Z1.4, except where otherwise indicated hereinafter. Unless otherwise specified, the Acceptable Quality
Limits (AQLs) listed in this section shall be used to establish the sample sizes, however, the acceptance
number shall be zero.
4.2.1 Inspection of components and materials. Unless otherwise specified in the contract or order, the
contractor shall inspected components and materials in accordance with all requirements of referenced
specifications, drawings, and standards unless otherwise excluded, amended, modified, or qualified in
this specification or applicable purchase document.
4.2.2 Examination of the end item for visual defects. The defects listed in table II shall be counted
regardless of their proximity to each other, except where two or more defects represent a single local
condition, in which case only the more serious defect shall be counted. The sample unit for this
examination shall be one tube. Not less than 100 feet from each sample unit shall be subjected to the
visual examination. The lot size for this examination shall be expressed in units of tubes. The acceptable
quality level (AQL) shall be 1.5 major defects and 4.0 total defects (major and minor combined) per 100
units. The inspection level shall be level I.
TABLE II. Classification of visual defects.
Examine
Defect
Classification
Major
Minor
X
Appearance and workmanship
Any cut.
X
Chafed or damaged.
Kink, broken strand, or loose
X
strand.
Unevenly braided resulting in open
places, breaks in continuity of
X
braid, or soft spots.
X
Finish gummy or tacky.
Color
Other than specified.
X
Cleanness
Spot or stain, clearly visible 1/
X
Identification label
Omitted or improperly attached.
X
Information incorrect or illegible.
X
1/ At normal inspection distance of approximately 3 feet
4.2.3 Examination for weight and winding. The sample unit for this examination shall be one tube. The
inspection level shall be S-3 and the AQL shall be 4.0 percent defective. The lot size shall be the number
of units in the inspection lot. Defects shall be as listed in 4.2.3.1 and 4.2.3.2.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business